Bright Kure & Seal was formulated to protect architectural concrete such as exposed aggregate, colored, and stamped concrete. A 26% solids, non-yellowing, cure and a seal made from pure 100% acrylic. It has been tested and approved by the Minnesota (DOT) Department of Transportation for the curing of decorative concrete surfaces. Available in a gloss and matte finish.
Bright Kure & Seal
TK Product’s Bright Kure & Seal is a 100% Acrylic concrete cure and seal that is 26% solids. Formulated in a gloss or matte finish, TK’s cure and seal has been approved by the Department of Transportation (DOT) in the use of curing decorative concrete surfaces in some states. Bright Kure & Seal can be used in interior and exterior on both freshly poured concrete as well as existing concrete surfaces for ultimate protection.
$70.50 – $214.00
TECHNICAL DATA SHEET | TDS CLICK HERE
TECHNICAL DATA SHEET (Spanish) | TDS CLICK HERE
SAFETY DATA SHEET | SDS CLICK HERE
Bright Kure & Seal suitable for interior or exterior use on new and existing surfaces. Ideal for exposed aggregate and colored concrete surfaces, paving block, patio stone, driveways, and garage floors.
When applying to exposed aggregate as a curing compound, the surface should be washed with a mild acid solution to remove the thin film of cement dust, then flushed with water and allowed to dry before applying BRIGHT KURE & SEAL.
At this point, a small mock-up area should be applied in an inconspicuous location to test the compatibility of the coating with the prepared substrate. Allow the coating to dry and cure fully, then inspect for proper film formation, gloss, and adhesion. Confirm that the film is free from whitening or any other defects.
Cure N Seal Benefits
- Meets the VOC regulatory compliance for AIM
- Superior penetration and adhesion
- Resists aggregate pop out and surface abrasion
- Color enhancing properties
Bright Kure & Seal Technical Information
Composition and Materials | A blend of 100% methyl/methacrylate acrylic polymers in a fast drying aromatic solvent.
Percent Solid | 26%
Flash Point | 105°F
Drying Time | Tack free: 1 hour
Open to Traffic | 2 hours
VOC Content | < 700 g/l
A.I.M. Category | Curing and Sealing Compound
Maximum VOC | 700 g/l
Applicable Standards:
- ASTM C-1315, Type 1, Class A, B & C
- ASTM C-309, Type 1, Class A & B and Type 1D with a red dye added.
- Fed. TTC-C-800A, Type 1, Class 1
- AASHTO Des. M-148, Type 1, Clear – DE CRD – C-300
- USDA Authorization for use in meat, poultry, and food processing plants.
- Resilient Tile Institute approval for compatibility with most resilient tile, carpet adhesives, and paints.
Reviews & Ratings
Only logged in customers who have purchased this product may leave a review.
Reviews